Thursday, January 19, 2012

What would cause a car battery to corrode quickly?

The positive cables attached to my car battery corrode so fast I have to clean them at least once a month. Does this mean the battery is bad?What would cause a car battery to corrode quickly?
first, IMPORTANT; wear eye protection around that battery of yours!! do not put your face over it when you are working on it. that bent post makes me worry for you. i have seen a battery explode! not trying to scare you, just warn you to be very careful when working on those terminals. you could short the battery out causing it to explode if the terminal snaps off. i think a crack in the case by the post is causing the corrosion. the acid is very corrosive so when you change the battery out wash down the tray with baking soda to neutralize the acid. then rinse with water to clean up the residue. be careful and good luck
Alternator malfunction?What would cause a car battery to corrode quickly?
Alternator malfunction. Ha Ha Ha that's a funny guess.
No. it means its dirty, clean it with a battery cleaning kit, then use battery grease to prevent corrosion and last



MOST IMPORTANT



keep your cable ends as tight as possible so it prevents vibration or movement.



A loose cable will corrode faster.What would cause a car battery to corrode quickly?
I would check the alternator first, although I do not think that that would help much. Take a volt meter and you should see approximately 14V at the battery when the car is on.



Check and make sure that the cable is tightly connected to the post. Use a light sandpaper to clean the post and the inside of the connector. Get some no-ox and put a light film around the battery post. You do not want to much as this stuff is non conductive. I usually apply with my finger and lightly wipe it off with a paper towel. There should be enough residue left on the post and then connect your cable.



No-ox is very cheap and can be found at most electrical supply stores, home depot, etc.
It needs to be cleaned properly, tightened properly and greased with a spray type grease not WD40. IT HAS NOTHING to do with the alternator, by the way.
First of all the connections need to be tight. After making sure they are tight you can cover the posts with a battery post spray on product that keeps out moisture which is the major cause of battery corrosion. You can also cover the battery posts with Vaseline or a light grease to accomplish the same thing however it's not as effective as the spray sealer. Make sure you don't have the battery (electrolyte) fluid level to full. No higher than the inside ring inside the the battery below the cap. If it's to high than this is where the moisture is coming from because as you drive you battery charges making the fluid warm which expands it and causes it to leak. Good luck
The post where the cable attaches may be broke loose from battery.
any battery that is not maintance free will leak acid and cause corrosion. they are cheap made and low price which lure customers in. if you want to cut down corrosion,the only battery that will do this a/c delco. BMW,LEXUS,TOYOTA,GM,HONDA start using a/c Delco on their vehicles to make customers happy

No comments:

Post a Comment